scalez
New To The Game
Posts: 7
|
Post by scalez on Oct 13, 2004 23:07:24 GMT -5
hey everyone. this is my first post here. hunted around for a key sampler for a while and finally settled on the ASR-10. This thing sounds great!
Anyways here's my question. I record a wavesample and tweak around with the start and end times on it so it's what i want.
then go into Layer edit. then go back into wavesample mode and I can't edit the wavesample any more. unable to edit the start or end times. it says "canot edit layer" or something like that. this is also the case if I have turned on loop forward and edited the loop start and loop end parameters.
is this just a limitation of the board or is it possible i'm doing something wrong?
|
|
scalez
New To The Game
Posts: 7
|
Post by scalez on Oct 13, 2004 23:08:05 GMT -5
i should also add that this is true for saved instruments i load up from disk. Can't edit wavesamples. again, is this as designed, or am i using it wrong?
|
|
DJames
New To The Game
Posts: 16
|
Post by DJames on Oct 14, 2004 0:57:01 GMT -5
make sure you press "edit", then select the WS you want to edit by just pressing that key. Make sure it does not say "all" then press "wave".
|
|